Open or short causes alarm.Ĭonnect as described for zones 7 and 8. Program location 37, segment 6, option 1.Ĭonnect to one side of zone 7 loop. Zone 8 may be used for a two-wire smoke detector usingĪ 680 ohm EOL resistor. Combined, this terminal and KP POS areĬonnect to one side of zone 8 loop.
Those jurisdictions which allow the Priority zone to be usedĬommon negative wire of powered devices such asĬonnect positive wire of all powered devices except Smoke detector power 12 VDC, 1.5 amps maximum (for Individually, this terminal is limited to 1 amp.Ĭombined, this terminal and AUX PWR+ are limited to 2 See Maximum Wire Run table.Ĭonnect to the common terminal on the keypads and theĬonnect to the POS terminal on the keypads and theĮxpanders. Maximum number of devices (keypads plusĮxpanders) is 32. The siren, which will cause these devices to output a smallĬonnect to the data terminal on the keypads and theĮxpanders. Resistor is used, you may experience voltage leakage into The bell terminals when a 12 VDC siren is used. Note: A 3.3 kohm resistor may be required across
Output becomes voltage output, 12 VDC, 1 Amp maximum If voltage ouput is selected in location 37, this Should be 15 watt at 8 or 16 ohm, or 30/40 watt at 4, 8, orġ6 ohms. If used as a siren output (default), the speaker rating Connect to a cold water pipe or a 6 to 10 ft. Connect to a 16.5 V 40 or 50 VA Class ll ULĮarth ground. Table 2 below describes the panel terminals.ĪC input.
0 kommentar(er)
